Windows Server 2008 Can Not See Static IP

Discussion in 'Site & Server Administration' started by avanetco, Feb 9, 2012.

0
  1. #1
    Windows Server 2008 can not see static IP. I recently installed Windows Server 2008 and set the IP address to static. Usually this is a simple process, but not this time. After setting the address to static the settings appeared to revert back to dynamic and DHCP along with DNS was not functioning. The only way to fix this issue is by doing the following:

    Launch Regedit
    Navigate to HKEY_LOCAL_MACHINE \SYSTEM\CurrentControlSet\Control\Network
    Delete the Config key as illustrated below.

    [​IMG]


    Next, Launch ncpa.cpl from the run box.
    Right click your Nic adapter and choose IPv4 and click Properties
    Set your static IP address
    Next, click OK and then close the property sheet.
    Restart your server.

    You now should have static IP addressing functioning on your server. Cheers
     
    avanetco, Feb 9, 2012 IP
  2. ideamine

    ideamine Member

    Messages:
    83
    Likes Received:
    2
    Best Answers:
    2
    Trophy Points:
    28
    #2
    ""After setting the address to static the settings appeared to revert back to dynamic and DHCP along with DNS was not functioning.""
    Are you sure you had set the settings correctly ?? Anyway thanks for sharing :)
     
    ideamine, Feb 9, 2012 IP