Trouble Adding AdSense Code...

Discussion in 'Support & Feedback' started by wwstewart, May 15, 2008.

Thread Status:
Not open for further replies.
  1. #1
    Hey, just a question. I've tried to add my AdSense code under my control panel, but it gives me an error about the formatting of the code that I put in being incorrect.

    As far as I can tell, I'm doing it EXACTLY as I'm told. Even to the point of knocking the ca- from the beginning of the code, and leaving the pub-[number].

    Anyone else having trouble? Suggestions? Am I just stupid? Anything helps...thanks.
     
    wwstewart, May 15, 2008 IP
  2. manHa

    manHa Peon

    Messages:
    677
    Likes Received:
    5
    Best Answers:
    0
    Trophy Points:
    0
    #2
    It takes 50 posts I think so perhaps you just don't have the permission yet?

    Just guessing.
     
    manHa, May 15, 2008 IP
  3. wwstewart

    wwstewart Well-Known Member

    Messages:
    713
    Likes Received:
    16
    Best Answers:
    0
    Trophy Points:
    140
    #3
    Well, I have the 50 posts, but it's new. On other forums, it doesn't even give the input field for the code unless you have the permission. Perhaps I should wait a bit and try it again.
     
    wwstewart, May 15, 2008 IP
  4. Smyrl

    Smyrl Tomato Republic Staff

    Messages:
    13,740
    Likes Received:
    1,702
    Best Answers:
    78
    Trophy Points:
    510
    #4
    Good idea. I believe permissions are set with a cron job so cron job may not have yet run.
     
    Smyrl, May 15, 2008 IP
  5. wwstewart

    wwstewart Well-Known Member

    Messages:
    713
    Likes Received:
    16
    Best Answers:
    0
    Trophy Points:
    140
    #5
    Thanks for the tip. I never thought of that...heh.
     
    wwstewart, May 15, 2008 IP
  6. esidyo

    esidyo Peon

    Messages:
    4,589
    Likes Received:
    316
    Best Answers:
    0
    Trophy Points:
    0
    #6
    I can see your ads now :)
     
    esidyo, May 15, 2008 IP
Thread Status:
Not open for further replies.