Hello, Our company is using shrink seals to cover the lids of our bottles. I need someone to turn our logo into a shrink seal template that I can send to the manufacturer. The design MUST be 5cm x 3cm!!! I am after 3 designs, all which revolve around the 1 logo. The logo is below but it is in the wrong colour http://i1113.photobucket.com/albums/k505/bovacompounding/BovaLogo-2747.jpg The logo above needs to be in the colour of the letter 'A' in the below logo http://i1113.photobucket.com/albums/k505/bovacompounding/bovalogo.jpg Here are the 3 designs I am after. They are very easy. 1. Below is a generic Shink Seal design that says "Safety Sealed" http://i1113.photobucket.com/albums/k505/bovacompounding/SafetySeal.jpg Make the BOVA logo the same size as "Safety Sealed" is and put it on the same angle and repeat the same amount of times width wise, repeat BOVA 2-3 times height wise. BOVA can be partly cut off at either the top or the bottom if need be. NOTE: DO NOT LEAVE SAFETY SEALED IN THIS DESIGN. I just want it to have the BOVA logo 2. I would like the BOVA logo to appear ONCE in the middle of the 5cmx3cm square. The BOVA logo should only be 1.3cm high (DO NOT SQUASH IT) and should be 0.7cm from the top and exactly in the centre. 3. I would like a design similar to #1 but I want it to have 2 lines that are repeated NOT one line. Line #1 - Should be the BOVA logo repeated 2-3 times Line #2 - Should say "Safety Sealed" NOTE: ALL these three logo's should be in the colour of the letter 'A' in Picture #2. Please contact me at ryan[at] bovacompounding.com.au if you can do this job. I will be more responsive to people that complete the designs in advance. Thank you