Attempt at creating the DP logo ... is it close?

Hello,

I have tried to as best as I can recreate the Digitalpoint Logo.

I am wondering if you guys can rate it on a scale of 1 - 10 of how close it is to the real logo 1 meaning least like and 10 exactly like.

Thanks

 

I recreated this for an avatar I made once, it's more challenging than it looks. I'd say the two vertical rectangle cut outs are too wide, but good job.

 

yea this one was a bit difficult im just trying to learn how to do it all I did was make a square rotate it so the points were on the side and top and then use the rulers to align everything made some circle cits and then rectangular selection cuts for the circles then to make the indented edges i used the warp tool which messed up the points so I jsut hand drew them back in.

 

I will give you 6 points.

 

Both sides (left&right) are too wide to make letters of 'd' and 'p'. However I will rate this as 8.

 

Exactly... the letters D and P are too wide.. I will rate this recreation as 7

 

I would rate 7.5
The gap in letters are too wide.

 

interesting for me, thanks

 

thanks for the commetns guys I will keep it in mind

 

I would rate it 8.5. Nice Job.

 

oh, so the logo is the letters d and p. never noticed that!

you get a 9 because your version looks better than the original.

 

@monosodium - I actually didnt notice that either for a while but thanks

 

its a good attempt, but if you look closely, it is more compact.