I want a very simple logo made. It's for a new brand of bumper plates called HANG bumpers. I want to make the H in HANG look like a barbell with two plates on it. I'm open to having it straight on view or having a bit of an angle so you can see the circular shape of the plates. I want the font to be very wide aswell similar to the skinny.jpg but a bit chunkier than that font. Also similar to the HUNG tv show font but wider. I need the logo to be just a shape because it will be imprinted in rubber. Similar to this http://www.fontspace.com/weknow/extra-large
Very nice, bumpers are all the same size so the blue logo wont work, good idea having 2 plates on each side of the bar to make it clearer that it's a bar with weights, it has to be molded from rubber so I will check the minimum mm gap between lines, could you try one where the HANG and the BUMPERS under it are the same font and maybe the same width?
Thank you so much for the feedback, here is the revision and i have seen more complex designs being printed perfectly so this should not be a problem i have balanced it more as well .. Better Preview Here : https://dl.dropbox.com/u/15310629/hangbumpersrev.jpg Thanx Shery
Hi, looks good, could you do it with both the plates the exact same size and width, also could you try with the lines of the font thicker. The problem is that this will be embossed in rubber on a weightlifting plate and if the lines are too thin they will break off... Thanks, Mick
i have made the font more thicker now and changed the plates of barbel and now they are of the same exact size check it out : https://dl.dropbox.com/u/15310629/revhangbumpers.jpg Thanx Shery