How to increase clicks rate?

I am getting clicks of about 20 per 1000 page impressions?

Is it too low? How i can iimprove the clicks rate?

Thank you for your suggestions.

My blog is flash2talk

 

What do you expect? You bombard your users with unrelated ads. Less spamming, more informing works wonders.

 

I would consider that "average". Try changing your ad placements and you might be able to get 5 or even 10 clicks for every 100 page impressions.

 

Improve on your content and study on the ads format/placement can increase your CTR

 

Dont worry it's going well i think this is good rate.

 

Think about add placement

 

Thanks for all your suggestions.

Can you help me specific about adsense placement in my blog

 

You should place ads of size 300X336 on the front so all can see it.

 

i may say that you change your template that suits your niche..

money right..

 

Well, how much does the Context Link service pay you per click? You may be losing Adsense clicks due to that other advertising service.

 

Thatz not a bad click rate

 

I googled a little and found an adsense guide for blogs.There are two ways which you should combine for best CTR: Change the colors of your advertisements. People tend to click depending on the colors of the advertisement. And place the advertisements at better locations.

Just read a little and I am pretty sure you will get your CTR up. Good luck.

 

Thank you Hendricius.

It will be helpful, if i get some suggestions specific to my blog after your review

 

I saw adsense ads and also bidvertiser, I think it is against adsense tos.

 

Concentrate on ad placements dude.. It will surely increase your click rate. Do u know link units give you high CTR?

 

Use minimum no of add blocks so that most relevant ads u get so that we can increase our ctr.

 

Try to place your ads better. It should not be hard to increase that at all.

 

Can some one confirm this? I am not sure about it?

Thanks for more suggestions regarding adsense placement in my blog

 

Place adsense ad inside an article.

 

How i can do it?

I am getting error message when i tried it.