System startup problem

hellooooo

i m getting probs in my pc while i m switching on the pc the msg show

[A DISK READ ERROR OCCURED PRESS CTRL+ALT+DEL TO RESTART]


press these key reboot the system and again this msg is showing
can anyone advice me wat to do ........

THANX....

regards:
ARUN

 

if ur using windows just use system restore option and switch back to a date when your pc was stable.

 

hello noneed


actu windows in nt running when i m switching on the system only the error msg is showing..........

 

I think your system needs formatting.

 

hello padalda


i tried to but the same error msg is showing.........

 

i tried to but the same error msg is showing.........

 

it seems your HDD has been damaged or its the failed memory modules.

 

remove the cables and put that once again some time it can be due to the cables (hdd data cables )

 

hello chandan123

i tried tat same the error msg is showing..............

 

are you booting from floppy by any chance ? check the floppy drive once and remove it if their any floppy

 

i hvnt got floppy drive.........

 

Restart and login in Safe Mode.
Then try the proper shutdown.

 

Hi There

I cannot beleive some of the stupid comments such "format and reinstall" or "reboot in safe mode".

It is quite clear that your PC is not picking up your HDD on boot so the above methods will never work

Reseat your HDD cables and make sure your HDD is showing up in the BIOS and it is set to boot from that.

Any questions just ask!

 

Agreed with this i hope u get relief with this otherwise New window or NEW HD

 

hello

HDD is showing in the bios n its set to the 1st boot divice.........after reseat the HDD cables same error is showing

 

OK find out the disk manufacturer and download the appropriate DOS diagnostics software from their site.

Most are listed on my PC Support Tools page

Burn to disk and test

Let me know how you get on and any questions just ask!

Regards

 

get hold of a WinXP CD that has a system recovery module,

run recovery, either an automatic, or thru command prompt run the command "chkdsk \r", (/ or \ )

if it works, you will get the system back, back up all your data, coz your disk has bad sectors,

if your disk is in warranty get it replaced, i got my seagate disk replaced, (free of charge)

else buy a new one, and you can use this as a slave disk.

M.

 

You should format your hard disk and restore the backup you have. everything will be fine....

 

hello

hw to use comand command prompt??

 

Hi There

Download UBCD

It has loads of HDD tools on there

Burn with ImgBurn (free)

Let me know how you get on

Regards